To obtain Motorola software see the Sticky in the Motorola forum.
It is YOUR responsibility to properly word your request. We do not want any hurt feelings when your vague post is mistaken for a free request. If you are having trouble legally obtaining software please state so. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. The same goes for any private transaction via Private Message. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. All requests will be deleted and a forum infraction issued. Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value.
But that was only once.Įverytime you switch it on now it goes into the self Cal Mode and then the flashing Copyright Screen and LED's.To anyone looking to acquire commercial radio programming software: It did on one occasion when I switched off and on it sprung back to life. I've checked all the voltage rails & all are OK as well as the 10Mhz Osc. I then left it for a few days, turned it on and it goes into auto Calibration and when it completes the screen goes blank and then the copyright notice flashes on and off as well as the red LED's forĪntenna & Gen out. So I switched it off for a few hours and when I came back to it and turned it on, Yes you guessed it, it's no longer worked on those ranges as mentioned above. Then I used it in that mode for a few hours and it worked Ok. I thenĭe-powered it a few times and it came back every time. I've since cleaned, checked and Buzzed out the ribbon cables, because only once when I re-seated the 3 going to the control board it started to work on the 5Mhz to 100Khz ranges. It worked fine in the 10Mhz and 25Mhz ranges, but when you pressed the more soft key as soon as you selected a range between 5Mhz and 100Khz the unit just locked up and the only way out of this was to de-power the unit from the mains. The problem I have is after I replaced the battery on the Control Board and Replaced ALL the Electrolytic Capacitors on the Power Supply Board, The Unit came back to life, and it worked onĪll functions except in Tracking Gene Mode. Can anyone Please help me out, I'm looking for a SERVICE Manual for the Motorola R2600 Test Set
0 kommentar(er)
